[Cube] Power button gasket

[Riba]

On 2008.04.03, at 02:50, phoenix wrote:
>> In a message dated 4/2/08 4:44:37 PM, riba at ml1.net writes:
>>
>> Does anyone have a spare power button gasket? A friend of mine got
>> himself a Cube and while taking it apart to clean it up he managed to
>> lose the gasket. :(
>
> To which Rsewill at aol.com <Rsewill at aol.com> wrote:
>> I used an address mailing label, the kind you run through a printer  
>> with
>> peel-off paper protecting the adhesive on one side.  I cut out the  
>> middle so
>> the light would shine through unimpeded and trimmed the edges to  
>> fit.  If
>> one label doesn't do it, use two, etc.
>
>     ... And that's how you do it. If one paper gasket doesn't do it,
> doubling up should be just fine. Either that, or wait for Powerlogix
> to create a super-special $9.99 o-ring insert :)

Wait a minute, I thought that you use the paper trick only when the  
sensor is too sensaitive, and it doesn't really help if the gasket is  
missing?