[Duo2400] Re: Palm sync problems

[R. McFarlane]

At 02:46 PM 1/13/2004, R. McFarlane, had this to say :

>The main issue still remains. Under 9.1 on the 2300c, HotSync does not see 
>the combo serial port (printer/modem).
>
>I received my MT G3 today in the mail and hooked it up and booted it. The 
>MT G3 ran fine, so I then docked my 2300c and booted up again. 
>Unfortunately, the G3 insisted on booting from the 2300c HD (no big deal 
>just not what I wanted), so I hooked up my new Palm serial dongle that I 
>also received in the mail today and changed the HotSync settings since it 
>was able to see the G3 modem port. Sync worked fine there. Going out now 
>so I will have to try a 2300c sync later.


Well I tried running the 2300c on it's own with the Palm dongle attached 
finally (up until now I was using a modem cable with adapters) and it 
worked this time. I am not sure if it is because the dongle was attached or 
the fact that when running on the MT G3 I was able to set it to a actual 
modem port. :S

Any ways, it works for now and if worse comes to worse I'll just have to 
dock the 2300c to the MT G3 periodically to sync. :)

Thanks to the list for the "second opinions". :D


Sincerely,

R. McFarlane

cross platform specialist
Mac - Linux - windows

McFarlane Computing
on-site/remote tutorials, support & training
(phone) 391-8972
(fax) 391-8972
(pager) 413-8577
(email) techie @ mcfarlanecomputing . net