[CUBE] problem installing JAG

[Hal]

Marty,

I had a similar problem installing Jag on my Cube (sock G4/500 with a 
GF3). The problem turned out to be firmware. 10.1 installed fine with 
the old firmware, but Jag didn't. After updating the firmware, it 
installed without a hitch.

Also, if you're more than 1 version behind, make sure to update the 
firmware 1 step at a time, you can't go from the really old all the way 
to the current in 1 shot. I spent about an hour trying to figure this 
part out...

hope that helps.

-Hal

> on 1/12/03 2:53 AM, Marty Levenson at martylev at telus.net wrote:
>
>> Dear List,
>>
>> Still can't install JAG.
>>
>> The Jag installer quits after it starts installing, and goes to a text
>> (terminal?) mode that says "Unexpected Shutdown (exit code 0) 
>> Restart" Tried
>> to install 10.1, but that installer quit too, about half way 
>> through....with
>> the same message.
>>
>> OS 9.2.2 runs great, and no other problems.  Any suggestions? I've 
>> run every
>> test on my partitions with TechTools Pro 3, and all seems well. 
>> Rebuilt the
>> desktop + zapped the pram.
>> Any possibility the battery is dying - could that cause be the cause? 
>> I know
>> the disk is good, as I installed Jag on my girlfriend's G4 tower with 
>> it.
>>
>> Going nuts in Vancouver,
>> Marty
>>
>>