[DuoList] Cardbus enabling

[Greg Glazier]

On Nov 22, 2004, at 2:00 PM, Morris Rieger wrote:

> I was browsing mac2400 earlier and noticed they requested anyone who
> successfully enabled Cardbus without using MCE to tell the list of
> their success.  Perhaps that request is a little dated, but I figured
> I'd inform everyone that I did, and it went without flaw.
>
> I had the resistor type of motherboard (not the jumper wires), so I
> had to yank the suckers off.  Just an FYI for you statistics buffs: my
> 2400c was manufactured in the 35th week of 1997, if that helps you
> determine when they switched to the yellow wires.  I did the entire
> procedure with my trusty Swiss Army knife [not recommended, by the way
> ;) ] and it took about 15 minutes from start to finish.  I could've
> done it faster, but I pretty much triple-checked every step.

***WHERE*** on Mac2400?

Anyone who's accomplished at soldering and unsoldering can do the mod. 
I've performed it on all 3 types of 2400C's. Usinf a Swiss Army Knife 
is just plain stupid. You could easily ruin the mobo that way.


--
Greg Glazier
The 2400C Doc

send all direct replies to:
retrotech at comcast.net