[G4] Re: G4 Digest, Vol 8, Issue 11

[Richard M. Kriss]

I don't recall any adhesive or hidden screws. You have to remover the whole
try and may have to pull your 120 GB drive.  The 20 should be held by 4
screws on the side.

Go to the OWC web page for a pictorial on how to

dick


On 4/14/05 1:15 PM, "g4-request at listserver.themacintoshguy.com"
<g4-request at listserver.themacintoshguy.com> wrote:

> I would now like to replace the original 20GB drive with another 120GB
> Hitachi Deskstar internal drive that I purchased.  But I have run into
> two problems/questions.  When I opened up my case, and removed the
> 120GB IBM drive to get to the 20GB drive, I discovered that the 20GB
> drive was not secured to the bracket by screws, but yet would not budge
> when I tried to remove it.  I didn't want to pull on it too much.  Is
> it held in place by adhesive, another screw, or is it just a little
> tight?  Please advise me as to whether I can just pull harder to get
> the drive out, or if there's something else I should do.