Audio sync problems

[sb]

This is a very common occurance when the audio was recorded at 12bit/32khz,
could be your problem.

You set the sample rate of the audio when you recorded it in the camera. Was
it 12 bit/32khz? Or, 16bit/48khz?

Check your camera, or if you have QT Pro, check the properties.

If you did not change your default audio in the camera, then it's most
likely recording at 12bit/32khz. Try converting to 16bit/48hz and then
reimporting the clip. QT Pro is very good, though a little slow, at
converting audio sample rates.

 sb

On 9/22/03 8:58 AM, "psullivan at knology.net" <psullivan at knology.net> wrote:

> Captured a 100 min video, but the audio is out of sync towards the end. Using
> TRV120 as a bridge and BTV Pro. Is this problem caused by the
> software or hardware? Workarounds? Have FCE or iMovie available.
>