In a message dated 10/4/05 12:09:17 PM, gskiii at verizon.net writes: > I've been having intermittent failures of the USB ports on the back > of my 17" Studio LCD display that has the ADC connector. Finally > called AppleCare and they had me reset PRAM and then boot into Open > Firmware (hold down cmd-opt-o-f on restart). That led to a bunch of > USB errors being generated and replicated the failure of those USB > ports. (I've kept a card reader that has a green light pugged into > one port so I can see when I've got problems...) The tech had me > type reset-nvram and then reset-all which rebooted. So far the > problem hasn't happened again. I may take the monitor in anyway > since I have less than a week of AppleCare coverage left. The tech > left and spoke to his manager about the problem and came back and > told me that it is very likely the display that is causing the > problem. This is a known problem. If you got AppleCare on the > display I'd take it in just in case. > > Regards, > Joey Kennedy. > Thanks for the Information. I wonder to what extent the Apple solution applies to a 20 " non ADC connector LCD monitor. Anyway, I am not worried since I have 27 months left on my Apple Care coverage so I can afford to wait it out and see if the problem reoccurs. , -------------- next part -------------- An HTML attachment was scrubbed... URL: http://listserver.themacintoshguy.com/pipermail/macdv/attachments/20051005/8fda2f3a/attachment.html