[CUBE] ThermoInDock shows constant 126 ° C on Cube

[Boris Jotic]

Am 23.04.2003 18:53 Uhr schrieb "Volker Schmidt" unter <volkomat at gmx.net>:

>> Some versions of the G4 do not have the built-in thermal monitor. I
>> didn't
>> think any of those made it into the cube, but you never know.
> 
> Ah. Am I correct, that there is no way to find out easily?

If you had one of the 7410 Thermo would constantly display -1°C

>> I have not used ThermoInDock in ages, but I seem to remember there was
>> a
>> calibration scheme. Perhaps there is some bad data in the calibration
>> area. I'd try trashing any ThermoInDock prefs you can find.
> 
> Been there, done that: No change.

Volker, I'd use a normal thermometer and put it inside the cube, above the
great heatsink, to measure the temp manually if it goes over 60°C somethings
wrong - perhaps the thermal paste between cpu and heatsink has "gone"...

Boris