[CUBE] isync

[Daniel A. Pinto]

Did not help, also ran Drive 10 no help.

Dan


On Sunday, Jan 5, 2003, at 10:26 US/Eastern, Bill Fox wrote:

> Try using Disk Utility to repair your permissions. This does wonders 
> for all kinds of X ills.
>
> On Sunday, January 5, 2003, at 09:40 AM, Daniel A. Pinto wrote:
>
>> I've installed Ical and isync on my 450 cube (10.2.3) but I can't get 
>> the palm conduit to install because the installer does not see palm 
>> desktop 4.0 which is installed.  It is like I need to rebuild the 
>> desktop as might have been the case in system 9.x.  Any help ?
>> thanks in advance
>
>
> ----------
> Check out the Cube email list FAQ
> http://www.themacintoshguy.com/lists/Cube.html
>
> To unsubscribe, E-mail to: <Cube-off at lists.themacintoshguy.com>
> To switch to the DIGEST mode, E-mail to 
> <Cube-digest at lists.themacintoshguy.com>
> Need help from a real person? Try.  
> <Cube-request at lists.themacintoshguy.com>
>
> ----------
> $14.99 Unlimited Nationwide Mac Dialup and Mac Web Hosting from your 
> Mac ISP Serious Mac Internet Solutions From NineWire!   
> http://macinternetaccess.com
>
> T3Hub  |  3 Port USB Hub weighs less than an ounce!
> Dr. Bott|   <http://www.drbott.com/prod/T3Hub.html>
>
>   Cyberian   | Support this list when you buy at Outpost.com!
>   Outpost    | http://www.themacintoshguy.com/outpost.shtml
>
> ADC Extension | Extend the built in cable of your flat panel by 10 ft.
>  Dr. Bott    |    <http://www.drbott.com/prod/ADCExtension.html>
>