[CUBE] Airport and Cube problem

[Martin Weiss]

>On Friday, Jun 27, 2003, at 23:06 Europe/Rome, Martin Weiss wrote:
>
>>	I've just transferred an Airport card from an iBook to a Cube 
>>and it is not recognized in System Profiler or the Airport Set-up 
>>assistant.. I re-seated it three times and it worked in the iBook. 
>>The CUbe has very little memory, merely 64 MB. Is this a factor or 
>>do I need to look further? Any suggestions?
>
>Don't know anything about memory and airport but you might want to 
>take off and reseat the connector of the airport holder just follow 
>the ribbon to the motherboard there is a piece of sponge that keeps 
>the connector seated properly just leave the sponge where it is and 
>disconnect and reconnect the connector.

Thanks. It was slightly unseated. Memory has nothing to do with 
Airport function just proper connections as in life, sometimes.

Cheers,

<Martin

>
>
>----------
>Check out the Cube email list FAQ
>http://www.themacintoshguy.com/lists/Cube.html
>
>To unsubscribe, E-mail to: <Cube-off at lists.themacintoshguy.com>
>To switch to the DIGEST mode, E-mail to 
><Cube-digest at lists.themacintoshguy.com>
>Need help from a real person? Try.  <Cube-request at lists.themacintoshguy.com>
>
>----------
>$14.99 Unlimited Nationwide Mac Dialup and Mac Web Hosting from your 
>Mac ISP Serious Mac Internet Solutions From NineWire! 
>http://macinternetaccess.com
>
>T3Hub  |  3 Port USB Hub weighs less than an ounce!
>Dr. Bott|   <http://www.drbott.com/prod/T3Hub.html>
>
>   Cyberian   | Support this list when you buy at Outpost.com!
>   Outpost    | http://www.themacintoshguy.com/outpost.shtml
>
>ADC Extension | Extend the built in cable of your flat panel by 10 ft.
>  Dr. Bott    |    <http://www.drbott.com/prod/ADCExtension.html>


-- 
Martin Weiss, Ph.D.
Director of Science
New York Hall of Science
47-01 111 th Street
Corona, New York 11368
phone: 718 699 0005 x 356
facsimile:718 699 1341
mweiss at nyhallsci.org
http://www.nyhallsci.org